Pullman Holt GB1400E Manuel d'utilisateur télécharger pdf (Page 14)

DAILY MAINTENANCE

3. REPLACING THE SQUEEGEE RUBBERS

Check the condition of the squeegee rubbers. Replace as necessary.

To replace the rubbers:

1. Lift the squeegee

2. Remove the two knobs

3. Detach the squeegee from its support

4. Remove the tube from the squeegee to permit the squeegee to be removed

5. Unscrew squeegee knobs that clamp the blades and pull them out

6. Remove the blades

7. Replace the rubbers

8. Reinstall everything by performing these procedures in reverse

4. DISASSEMBLING THE BRUSH

1. Lift the squeegee

2. Lift the machine by using the handlebars as a lever and position it with the

recovery tank on the ground

3. With the base lifted, remove the brush manually by rotating it clockwise

ATTENTION: Disconnect the power cable from the mains

socket before carrying out any maintenance operations.

ATTENTION: Make sure there are no objects or persons in the

vincinity of the brush when doing this operation.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Pullman Holt GB1400E Manuel d'utilisateur Page 14